Effect of lubricant sulfur on the morphology and elemental composition of diesel exhaust particles

This work investigates the effects of lubricant sulfur contents on the morphology, nanostructure, size distribution and elemental composition of diesel exhaust particle on a light-duty diesel engine. Three kinds of lubricant (LS-oil, MS-oil and HS-oil, all of which have different sulfur contents: 0.182%, 0.583% and 1.06%, respectively) were used in this study. The morphologies and nanostructures of exhaust particles were analyzed using high-resolution transmission electron microscopy (TEM). Size distributions of primary particles were determined through advanced image-processing software. Elemental compositions of exhaust particles were obtained through X-ray energy dispersive spectroscopy (EDS). Results show that as lubricant sulfur contents increase, the macroscopic structure of diesel exhaust particles turn from chain-like to a more complex agglomerate. The inner cores of the core-shell structure belonging to these primary particles change little; the shell thickness decreases, and the spacing of carbon layer gradually descends, and amorphous materials that attached onto outer carbon layer of primary particles increase. Size distributions of primary particles present a unimodal and normal distribution, and higher sulfur contents lead to larger size primary particles. The sulfur content in lubricants directly affects the chemical composition in the particles. The content of C (carbon) decreases as sulfur increases in the lubricants, while the contents of O (oxygen), S (sulfur) and trace elements (including S, Si (silicon), Fe (ferrum), P (phosphorus), Ca (calcium), Zn (zinc), Mg (magnesium), Cl (chlorine) and Ni (nickel)) all increase in particles.     

Determination of 15 phthalate esters in air by gas-phase and particle-phase simultaneous sampling

Based on previous research, the sampling and analysis methods for phthalate esters (PAEs) were improved by increasing the sampling flow of indoor air from 1 to 4 L/min, shortening the sampling duration from 8 to 2 hr. Meanwhile, through the optimization of chromatographic conditions, the concentrations of 9 additional PAE pollutants in indoor air were measured. The optimized chromatographic conditions required a similar amount of time for analysis as before, but gave high responsivity, the capability of simultaneously distinguishing 15 kinds of PAEs, and a high level of discrimination between individual sample peaks, as well as stable peak generation. The recovery rate of all gas-phase and particle-phase samples of the 15 kinds of PAEs ranged from 91.26% to 109.42%, meeting the quantitative analysis requirements for indoor and outdoor air sampling and analysis. For the first time, investigation of the concentration levels as well as characteristics of 15 kinds of PAEs in the indoor air from four different traffic micro-environments (private vehicles, busses, taxis and subways) was carried out, along with validation of the optimized sampling and analytical method. The results show that all the 9 additional PAEs could be detected at relatively high pollution levels in the indoor air from the four traffic micro-environments. As none of the pollution levels of the 15 kinds of PAEs in the indoor air from the 4 traffic micro-environments should be neglected, it is of great significance to increase the types of PAEs able to be detected in indoor air.     

关于渗透通风条件建筑结构对室内PM2.5浓度水平影响评价模型探讨

我国京津冀地区近年频遭大气PM_2.5污染侵扰,相关研究表明,既使关闭建筑外窗,大气中PM_2.5仍可以通过渗透通风方式进入室内污染环境.为定量评价建筑渗透通风及无室内污染源条件下建筑结构（如外窗缝隙结构、房间建筑结构等）对室内ρ（PM_2.5）的影响规律,基于北京市东城区、朝阳区6个不同建筑结构的房间室内外ρ（PM_2.5）实时监测数据,重点比较分析了建筑结构对室内外ρ（PM_2.5）关联特性的影响规律.此外,根据颗粒物穿透特性及沉降特性机理,提出了反映建筑外窗缝隙结构（如缝高、缝深）的无量纲特征参数A_P与反映房间建筑结构（如层高、开间、进深）的无量纲特征参数A_k.在前期提出的室内ρ（PM_2.5）预测模型基础上,进一步构建了二者（A_P与A_k）对室内ρ（PM_2.5）影响的评价模型,并通过实测数据验证了模型的正确性.结果表明:当室外PM_2.5污染程度与气象条件一定时,建筑结构对I/O[室内外ρ（PM_2.5）之比]影响较大,其范围在0.4~0.7之间;随着建筑外窗气密性等级的提高,对应室内ρ（PM_2.5）呈显著的下降趋势.建筑外窗缝隙结构对室内ρ（PM_2.5）影响程度远大于房间建筑结构,敏感性分析结果表明,当建筑外窗缝高每降低50%或缝深每提高50%,对应室内ρ（PM_2.5）约可下降33.6%与31.9%.研究显示,气密性等级较高的建筑外窗缝隙缝高往往较小、缝深较长,渗透通风条件下对控制室内ρ（PM_2.5）水平作用更显著。      

基于GeoDA的江苏省长江总磷空间关联度分析研究

利用地理空间分析方法和空间分析软件,采用2006年-2015年江苏省长江10个干流和45个入江支流监测点位的总磷浓度数据的年平均值,分析了江苏省长江干流和支流总磷浓度的空间相关性及其时空演变特征.分析发现长江总磷污染呈现全局正相关,相关指数总体呈现先减小后增加的趋势,直至2015年增至最大,干流总磷污染的重心先向西北后向西南移动,支流总磷污染的重心先向西北再向东南移动,重心移动幅度不大,并且二者均有向北面移动的趋势,同时移动幅度接近,长江干流总磷污染与支流的汇入是密不可分的.     

环境资源禀赋视角下产业升级路径研究——以浙江为例

本研究以浙江省为例,立足环境资源禀赋的优势和不足,进行产业发展现状和环境资源禀赋的相容性分析,剖析产业发展存在的问题,探索新时期环境资源禀赋支撑产业升级的路径与模式,提出浙江省基于环境资源禀赋的产业发展原则和思路,要支持发展符合环境资源条件和顺应产业发展规律的优质产业,限制发展不符合环境资源条件的低端产业,建议重点发展知识技术密集型产业、海洋经济和临港产业、生态休闲养生产业、现代大农业,并积极推进传统产业转型发展.     

呼和浩特市可镇污水处理厂工程设计

呼和浩特市可镇污水处理厂近期建设规模1.0×104m3/d,远期总规模2.5×104m3/d。污水处理主体工艺采用组合式A2/O生化池+砂滤,污泥处理采用污泥贮池+带式浓缩脱水一体机,尾水采用液氯消毒,设计出水水质执行GB 18918—2002《城镇污水处理厂污染物排放标准》一级A排放标准。介绍了该工程的工艺流程、设计参数,总结分析了工艺设计的技术特点。同时阐述了针对低温条件下的运行保障措施和要求,为寒冷地区同类污水处理厂的设计提供参考和借鉴。     

废弃SCR脱硝催化剂的再生及其脱硝性能研究

对废弃脱硝催化剂处理后重新加工再生,研究了添加剂对其粉体成型和再生催化剂脱硝活性的影响,探讨了反应温度、空速、n(NH3)∶n(NO)摩尔比、氧含量、H2O和SO2对再生催化剂NH3选择性催化还原(SCR)NO的影响。结果表明:最佳再生条件是使用5%羧甲基纤维素和10%无机粘结剂辅助成型;废弃催化剂再生利用率高达90%;再生催化剂抗压强度为4.73 MPa,优于商用催化剂;空速5 000 h-1、氨氮摩尔比1、氧含量6%时,脱硝活性温度窗口为310⁴50℃,350℃时活性最高为94%;350℃时,单独通入1 000×10-6SO2或10%H2O对再生催化剂活性均有一定抑制作用,最低活性分别为70%和81%,停止通入SO2或H2O后其活性逐渐恢复;同时通入1 000×10-6SO2和10%H2O,再生催化剂活性下降至63%并于1 h内保持相对稳定,停止通入SO2和H2O 2 h后,活性逐渐恢复到73%。     

Decrease of NH4+-N by bacterioplankton accelerated the removal of cyanobacterial blooms in aerated aquatic ecosystem

We used aerated systems to assess the influence of the bacterioplankton community on cyanobacterial blooms in algae/post-bloom of Lake Taihu, China. Bacterioplankton community diversity was evaluated by polymerase chain reaction-denaturing gradient gel electrophoresis(PCR-DGGE) fingerprinting. Chemical analysis and nitrogen dynamic changes illustrated that NH4+-N was nitrified to NO2-N and NO3-N by bacterioplankton. Finally, NH4+-N was exhausted and NO3-N was denitrified to NO2-N, while the accumulation of NO2-N indicated that bacterioplankton with completely aerobic denitrification ability were lacking in the water samples collected from Lake Taihu. We suggested that adding completely aerobic denitrification bacteria(to denitrify NO2-N to N2)would improve the water quality. PCR-DGGE and sequencing results showed that more than 1/3 of the bacterial species were associated with the removal of nitrogen, and Acidovorax temperans was the dominant one. PCR-DGGE, variation of nitrogen, removal efciencies of chlorophyll-a and canonical correspondence analysis indicated that the bacterioplankton significantly influenced the physiological and biochemical changes of cyanobacteria. Additionally, the unweighted pair-group method with arithmetic means revealed there was no obvious harm to the microecosystem from aeration. The present study demonstrated that bacterioplankton can play crucial roles in aerated ecosystems, which could control the impact of cyanobacterial blooms in eutrophicated fresh water systems.     

Effects of physical and chemical characteristics of surface sediments in the formation of shallow lake algae-induced black bloom

Surface sediments are closely related to lake black blooms. The dissolved oxygen （DO） distribution and its penetration depth in surface sediments as well as the migration and transformation of redox sensitive elements such as Fe and S at the sediment-water interface are important factors that could influence the formation of the black bloom. In this study, dredged and undredged sediment cores with different surface properties were used to simulate black blooms in the laboratory. The Micro Profiling System was employed to explore features of the DO and ∑H2S distribution at the sediment-water interface. Physical and chemical characteristics in sediments and pore waters were also analyzed. The results showed that sediment dredging effectively suppressed the black blooms. In the undredged treatment, DO penetration depth was only 50 μm. Fe^2＋ concentrations, ∑H2S concentrations, and ∑H2S production rates were remarkably higher in surface sediments and pore waters compared to control and dredged treatments. Furthermore, depletion of DO and accumulation of Fe^2＋ and ∑H2S in surface sediments and pore waters provided favorable redox environments and necessary material sources for the blooms. The study results proved that physical and chemical characteristics in surface sediments are important factors in the formation of the black bloom, and could provide scientific guidance for emergency treatment and long-term pre-control of black blooms.     

中国PM2.5管理策略研究

文章通过对PM2.5的基本组成、来源与影响因素的分析,构建中国PM2.5全过程管理体系,建立、完善PM2.5削减和控制长效机制,进而实现中国PM2.5管理。